Horizontal Stabilizer Hinge Bracket Alignment
Submitted by John Schroeder
This is a supplement to the Builder’s Hint published by Neal Garvin describing a new way to align the hinge brackets on...
Glasair Gear Door Gaps
Submitted by Neal Garvin
If your wing is still in the wing jig (and upside down) then the best way is to build the doors...
Electric Trim Option for the Glasair Elevator
Submitted by Jim Dutton
During an e-mail discussion about elevator trim systems, with Dick Dobson and Brooks Robinson, Dick mentioned he had installed an electric...
Fitting the Glasair Cowling Before the Prop is Installed
Constant-speed propellers and even fixed-pitch units are a significant investment, and often there is a significant lead time between ordering and delivery of the...
Locating and Center-Punching Holes
You may have the best tools, but it's knowing how to use them that makes you a craftsman - in this case our members...
Nose Gear Wheel Fairing
Submitted by Don Jessup, Wellsboro PA, Glasair Super II FT
When you are fitting the nose wheel fairing the manual suggests a 7/8" space above the wheel fairing...
Stopping Cabin Air Outflow
This tip was submitted by Tom Hoffman, Glasair III.
Cabin ventilation in all Glasair models has always been excellent and entirely adequate through two eyeball vents....
Instrument Panel Washers
This tip was submitted by Barry Bieber Glasair II-S RG
If you're trying to build a showplane, don't bother trying to use allen head instrument...
Beating The Draft
Written by Fred Van Rader, Glasair II-S RG
Have you cured that big draft that enters your Glasair cockpit from the cutouts in the 'B' ribs?...
Glasair Elevator Trim Cable Crimping Tool
The 3/64" elevator trim cables in the Glasair are secured with two NicoPress sleeves (P/N 450-0002-015) per end. Stoddard-Hamilton supplies these sleeves because they’re...