Glasair Tail Light Mounting Block
The instructions for the Glasair call for the cutting of 2 small triangle shaped pieces of aluminum and bonding them in and then drilling...
Glasair I Flap Ratchet Plate
Submitted by Stan Gorman
Flap actuation is much easier with this "saw tooth" ratchet plate, especially 35° and 50° position.
Note: Glasair II & III ratchet...
GlaStar Exhaust Alternative
After 900 hours and one or two welding repairs our stock GlaStar exhaust was no longer serviceable or able to be repaired. The stock...
Cast Rudder Pedals
This tip was sent by Chris Lowery.
I never did like the cheap riveted metal plates SHAI had us make as rudder pedals, and nor...
Turbine Glasair G-I
One of the "fun" aspects of working the Technical Support desk is we get a sneak preview of what some of the builders are...
Upgrading a G-I Wing to G-II Configuration
The original G-I wing can take advantage of a number of later kit components and component locations.
First the fuel tank capacity can be increased...