Glasair Wing Rotation Jig
This tip was submitted by Jerry Shilt.
The picture is of some jigs I made to rotate the wing by myself and as you can...
Glasair Exhaust Systems
Noise
Noise, as it pertains to our discussion here, is simply unwanted sound. Many people are bothered and angered by aircraft noise. Although in metropolitan...
Nutplate Jig
Submitted by Don Jessup.
Don't delay—make yourself a metal template to drill all the holes you will make for nutplates. About 1" x 2" seems...
Taming the Tail Wheel Shimmy
Written by Will Fox, Technical Counselor, EAA Chapter 691, Los Alamos, New Mexico
Ever had a tail wheel shimmy on you? If you haven’t, consider...
Glasair Aft Chord Line Board
Submitted by Fred & Chris Van Raden, Glasair II-S RG builders
After wing closing and before removing the wing from the jig, install the wing...
Glasair Gear Down Problem Avidance
Submitted by Bill Kramer, Glasair III builder.
During recent gear cycle tests, I discovered a problem. The gear would retract but would not extend. After...
Installing Glasair Rear Windows
Submitted by Mike Palmer
Here are some tips on installing the rear windows for those who don't have the new flanged Glasairs:
1) Be aware that as...
Water Level Using PVC Pipe
Submitted by Bob Buckihal
Here's an idea that you might pass along to others. For $20 at the local hardware store, I was able to...
Glasair Wing Closing Tip – Checking for Water Traps
Submitted by Bob Buckihul
In preparation for wing closing, I scrubbed out the fuel tanks with water and Simple Green. After lots of scrubbing and...
Aileron Fabrication and Counterweight Installation
Submitted by Charles Lutin
While building my Glasair Super II, I have been highly impressed at the strength and quality of the construction produced by...