Spray Gun Lowdown

This tip was submitted by John Top.

I had never owned a paint gun, and I researched them for my GlaStar project. I settled on the Binks M1-G, which is a gravity-feed high-volume/low-pressure (HVLP) gun. It complies with all air quality regulations with very low overspray and a 65% transfer efficiency. It requires only 18 lb of inlet pressure. It will handle all types of materials—including waterborne and high-solids—as fast as a conventional gun with a 50% material savings.

Advertisement
Binks M1-G HVLP spray gun.
Binks M1-G HVLP spray gun.

I kind of assumed that all HVLP guns were equally expensive or took a lot of added equipment until I saw a very informative ad from A&I Supply, which included a matrix comparing the Binks conversion system with a turbine HVLP on various points. I gave Binks a call, and after talking to their techies, gave A & I a call and talked to their techies. They recommended the gravity-feed M1-G gun, which will work with the small 3–5 hp compressor with a 25–30 gal. tank that most of us probably have.

A&I sells the gun for $269, which is not much more than the conventional DeVilbis gun Cleaveland offers, and you’ll probably save the difference in materials. (A&I ships orders over $50 for free.) It’s more expensive than what you’ll find at Home Depot or Sears, but if you want a quality gun at a good price, you can’t beat it.

When I talked to Binks, I mentioned that S-H was recommending a Binks Model 7 or equivalent with a #36 nozzle for the Deft primer they sell. The Binks techies said that the M1-G with their #94 fluid nozzle and #95 air nozzle will handle anything that the S-H setup will.

So far, I have used my new gun to finish-paint my engine mount. After 10–15 minutes of spraying, I was amazed that I had only gone through 3 oz. of paint. Had I bought this gun earlier, I probably wouldn’t have needed to buy an extra quart of PPG at $70! The gun can be choked down to less than an aerosol can, which keeps runs to a minimum.

I see no reason why it wouldn’t work as well with primers. Most turbine guns will not handle water-based materials, and those that do require them to be thinned. However, the Binks conversion HVLP guns are purported to do a great job of atomizing water-based coatings, many without thinning.

Funny how you tend to get what you pay for when it comes to tools!

Advertisement
Previous articleTechnique for Cutting Stainless Engine Mount Backing Plates
Next articleGlasair Engine to Fuselage Alignment
GAOA Members
Our members regularly send tips for publication on the GAOA website.