Sportsman Service Bulletin 71

Glasair Aviation has issued a service bulletin requiring inspection of the jam nuts in the horizontal stabilizer.

Advertisement
Left: AN315-6R (Incorrect part); Right: AN365-624A (Correct part)

Russ Beers reports that he purchased a 2 meter long borescope that has integral LED lights and requires only a laptop with USB port to power. This can be valuable in doing inspections in those hard to see areas. The picture quality isn’t bad and you can capture stills or video. Not bad for less than 15 dollars! Fits into spark plug holes, too.
Search the web for USB endoscope camera.

SUBJECT: HORIZONTAL ALIGNMENT PIN NUT

APPLICABILITY: Sportsman Pre-Built Horizontal Stabilizer and Two Weeks to Taxi Aircraft shipped between August 2012 and April 2014

Date: May 5, 2014

DISCUSSION: There may be some Pre-Built Horizontal Stabilizers that have AN315-6R Jam Nuts installed instead of AN365-624A Nuts.

REQUIRED ACTION: Before your next flight, remove Horizontal Stabilizer and check the nut that holds the Horizontal Alignment Pin. If the nuts and washers are not AN365-624A self-locking nuts and AN960D616 washers, then contact the Glasair Aviation parts department at: parts@glasairaviation.com or 360-435-8533 X 221 and order the parts at no charge.

Download SB 71

[download id=”2363″]

Advertisement
Previous articleServo vs. Anti-Servo
Next articleKeeping Oil Temperatures Low
Omar Filipovic
Omar Filipovic is president of the Glasair Aircraft Owners Association as well as the chief tinkerer and content editor for this website. He is also the web editor for Kitplanes Magazine. Omar is building a GlaStar in Portland, Oregon.