Images tagged "ailerons"

Phoenix Composites Aileron Trim
Here is an end view of the completed aileron.
Attaching the Aileron Hinges
Flap/fuselage transition on Rod Benson's GIII
Aileron trim
Transponder Antenna
Continued building the ailerons.
Continued building the ailerons.
Fabricated aileron actuator fittings and laminated all the flap ribs. These are the fittings after powder-coating.
Aileron Bellcrank Installed In Wing
servo - autopilot
Aileron Closure
Flap Actuation Linkage
Wing Tip Detail
Continued building the ailerons.
Continued building the ailerons.
Aileron Trim
Aileron Trim On Rod Benson's Glasair III
bl-7718-1
Optional Fuel Tank: Step 1. The approximate location of the forward and side fuel bulkheads are traced onto the inside of the lower wing panel using the dimensions in the Stoddard & Hamilton manual for the Glasair III optional fuel tank. This will aid in fitting the panels, tunnel and clearing the bellcrank and aileron control rods. Next, 2(two) panels (38 X 6 1/2) were fabricated from 1/4 foam with 2 layers of LAMs on each side. Each panel will be used to make the 4 pieces needed for the left and right optional fuel tanks (see diagram). When you trim the panel, do not waste any pieces, as they will be used later. From the panel, cut the forward fuel panel section and fit it to the wing tank forward panel area making sure to clear the aileron control rods (about 5 3/4 X 31). Save the long skinny piece of panel that is to be attached behind the forward panel (3/4 X 30 1/2). It will be used in step 5. The other trimmed end piece (7 1/2 X 6 1/2) will be used in step 10 & 11 to make the side panels next to the bellcrank.

[Show slideshow]
1 2 ... 5